升降机启动时注意啥？

1.运输的物品在台面上尽可能的分布均匀防止偏载,并禁止超载运行。升降平台不允许载人和装运易燃易爆等危险物品和禁止在升高时人员攀爬以及人为摇晃。Lift manufacturers to remind that the transport of goods on the table as far as possible the distribution of uniform to prevent partial load, and prohibit overloading operation. Lifting platform does not allow manned and shipment of flammable and explosive and other dangerous items and prohibit the increase in personnel climbing as well as human shaking.

2.工作前将防护栏两端的活动门关牢锁死后鸣铃起动,严禁在防护栏活动门敞开不关闭情况下工作，在升降平台行驶中如遇特殊情况可使用急停开关目的停止升降平台运行,但在正常运行中,禁止使用急停开关停车。Work before the fence at both ends of the movable door lock ring fastened after starting, is strictly prohibited in the fence door open not to close the case, the lifting platform running in exceptional circumstances such as the use of the emergency stop switch to stop lifting platform operation, but in normal operation, the prohibition of the use of the emergency stop switch to stop.

3.升降机工作时候严禁离开岗位和对升降平台进行揩拭、润滑或者修理等操作工作.当工作完毕后,司机应切断电源,锁上控制盘才可离开岗位,并填写好司机交接班记录。When the lift is working and to prohibit leaving post or repair operations such as wiping and lubrication of the lifting platform work. When the work is finished, the driver should cut off the power supply, the lock control panel can only leave the post, and fill out the log driver.

4.在每日工作前必须认真检查升降机的电器系统、液压系统以及机械系统是否正常,是否有故障，并将升降平台上下空载试行数次,检查有无故障和不正常现象,还必须注意升降平台台面停层站准确度有无显着不正常的差距等等可能存在问题的地方。The lifting platform manufacturers that, in daily work must be carefully checked before the elevator electrical system, hydraulic system and mechanical system is normal, if there is a fault, and the lifting platform under no-load trial several times, check the fault and abnormal phenomenon, we must also pay attention to the lifting platform station stop layer accuracy have no significant abnormal gap may be a problem where.

5.按下“上升”或“下降”按钮，使升降平台工作台正常升降。如果工作平台不动，应立即停机进行检查防止安全事故的发生。Lift manufacturers to remind, press "up" or "down" button, so that the lifting platform of the normal lift platform. If the work platform does not move, should be immediately stopped to check to prevent the occurrence of safety accidents.